Publish Time: 2024-03-27 Origin: Site
1. First of all, the correct installation, the cooling system must be grounded, the need for regular cleaning of the water tank of the water circuit, refrigeration and water tank temperature control should be reasonable, otherwise there will be a laser tube breakage and condensation of the power has decreased, the tube of the cold water head will be off, will reduce the service life, and sometimes there is no way to work, the need for non-stop to change the tube, it is more trouble.
2. Laser tube installation should pay attention to the installation of the tube pivot point should be reasonably installed, the pivot point needs to be installed to a quarter of the total length of the laser tube, to avoid causing the laser tube spot pattern deterioration, otherwise there will be a period of time after the equipment will work, the spot will turn into several, resulting in a decline in laser power can not meet the requirements of the work, resulting in the unnecessary replacement of the tube.
3. Laser cutting machine who protects the device need to arrange for regular maintenance and cleaning, the cooling water of the equipment because it can not ensure that the flush who protects the float switch, or water protection float switch is not reset, is not a short method to solve the current problem, be sure to do a good job on a regular basis to maintain.
4. equipment suction device need to arrange for people to regularly check and clean up, keep the fan pipe clean, otherwise it will cause a lot of smoke and dust can not be discharged out of the situation, which will directly endanger the lens and laser tube, resulting in contamination, and let the other mechanical electronic components oxidation, resulting in poor contact leading to laser cutting machine equipment failure. Problems can be timely contact laser equipment manufacturers technology to seek support.
5. Laser cutting machine working environment can not be too dirty, the working environment can not be too harsh, for example: the equipment working environment is higher than 30 degrees, or lower than 18 degrees, the workshop's dust is relatively large, air pollution is more serious case, will accelerate the wear and tear of the equipment, equipment failure rate will also have to rise, if the environment is more humid situation, the equipment's electrical parts are also more tolerant of you appear! Some problems.
6. Laser cutting machine light intensity at work must be used reasonably, the work can not be in a long-term 90-100% light intensity working condition, to rationalize the use of laser equipment and save laser light energy, optical system should be cleaned up regularly, otherwise it will lead to accelerated aging and rupture of the laser tube, affecting the service life of the laser tube, so the laser work, light intensity should be adjusted between 50-60%, and then according to the desired need for the light intensity, the light intensity should be adjusted between 50-60%, and then the light intensity should be adjusted between 50-60%, and then according to the desired need for the light intensity. 60%, and then according to the material to be processed, to adjust the speed of the equipment to complete the normal process of the equipment.
7. For laser cutting machine consumables focusing lens and reflector inspection work must be done, in the equipment after a period of time, the frame will heat, lens surface discoloration, rust, flaking, cracking under the clear suffering, are the need to replace the parts from the new, especially some customers use large air pumps and compressors, the water will soon be gathered in the focusing lens above, so be sure to regularly check the lens optical system clean and quality. Lens optical system cleaning and quality, found that there are problems with the accessories, you need to contact the laser equipment manufacturer in a timely manner to replace.